YUEQING JIUHONG ELECTRIC CO .,LTD
YUEQING JIUHONG ELECTRIC CO .,LTD
Add to Cart
JH - 1908 Stainless Steel Banding,Strapping Tool forTensioner And Cutter
With the function of tensioning & cutting etc,suitable for strap banding, stainless steel cable tie.
Cable tie width:8mm to 20mm,thickness:0.25mm to 1.5mm
Instruction Guide:
1. Band may be used from bulk roll as this completely eliminates waste of band.Slide buckle on band as shown,bringing end of band around object to be clamped and again through buckle.Note:The tension screw theread should be lubricated regularly.
2. Continue band around object on more and again through buckle.Double banding develops a great deal more radial compression than sing banding.Bend end of band under buckle
3.Place band in opening of tool nose and gripper block.Move into slot as far as possible,to avoid buckle sliding into tool nose.Tighten band clamp by turning the tension handle clockwise while holding band gripper tight against band.NOTE: The spring load of the band gripper is not intended to secure and prevent band from slipping during tension process